We advise that springs be replaced every two years on any spring equipment to ensure optimal performance of your equipment.

Springs on most equipment including reformers should only be replaced as sets - this ensures that an accurate record can be kept when all springs have been replaced.

For more tips on equipment and maintenance care, download our Large Equipment Inspection & Maintenance Schedule for recommended guidelines and a full checklist.

Spring Holder Replacement Kits will be necessary if you purchased V2 Max®, Pro or SPX® series Reformer before December 2011 and have not replaced your spring holder yet. You do not need to upgrade your spring holder if your Reformer was purchased after December 2011.

If you’re unsure when you purchased your Reformer, you can easily tell by looking at the Spring Holder on your Reformer.

Does your Reformer have…

Molded Spring Holder: No,an upgrade kit is not required

Spring webbing board: Yes,a Spring Holder Upgrade Kit is required

Spring loops: Yes,a Spring Holder Upgrade Kit is required

If you’re still unsure, please contact us at 1300 911 441.

You can easily find the serial number by referring to your owner’s manual that you received with your equipment or by locating it on the equipment.

In your owner’s manual

Serial number can be found on the back of your equipment manual

Reformer

Serial number can be found on the back-end, below the rail on the left side

Note, if you have an At Home SPX® Reformer your serial number may be found on the back left underside of the Reformer rail

Cadillac/Trapeze Table

Serial number can be found on the bed frame (below the table top) on a corner receptor

Stability Chair™

Serial number can be found on the chair seat, below the spring sticker

Vertical Frame

Serial number can be found to the left of the lower horizontal bar

Wall Unit

Serial number can be found on the middle support on the backside of the wall unit

Spring Wall

Serial number can be found on the top left edge with the number facing the front

Tower Trainer

Serial number can be found on the end of the mat frame

Need guidance on how to replace the springs on your equipment? See our easy to follow installation guide and video for quick and easy spring and spring holder replacement.

Have questions? Contact 1300 911 441

See our Spring resistance chart (PDF) for calculation steps